Idec DATAVS1 Series Instrukcja Użytkownika Pobierz pdf (Strona 36)

Instruction Manual SVS1 Series

It is also possible to set a delayed image acquisition compared to the trigger signal received for both

hardware triggers. To set the delay value, simply use the slider found at the bottom of the screen using

the RIGHT/LEFT ARROW buttons.

Example:

The image acquisition is delayed by 150 ms compared to the rising edge of the trigger signal.

6.3. Bankset

The te

rm bankset

identifies the control panel used to manage the databank areas available on the

sensor.

NOTE: The bankset is the only access point to the FLASH memory installed on the sensor. During all

configuration steps in fact, a RAM type memory is used which is reset each time the device is

powered down. Therefore, when the current settings are modified, and you wish to render them

permanent, it is necessary to save the inspection tool using the bankset.

The 8 memory slots available on the sensor are displayed at the top of the screen. Each bank can

take on three different status modes (identified by 3 different colours):

• Current bank (white)

Current memory slot

• Free bank (green)

Free bank

• Full bank (yellow)

Memory slot full. If you save a new inspection to this slot, it will overwrite the previous

version.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 82 83

Brak uwag

Idec DATAVS1 Series Instrukcja Użytkownika Strona 36